Preparation

Make sure that the surfaces are clean, sanded, and free from contaminates.  Best results are achieved by adding some silica thickener to the G2.  Also, apply only enough clamp pressure to close the joint.  Over clamping will squeeze out the G2, resulting in a weak bond. 

See Technical Data Sheet or container for surface prep information.

See Technical Data Sheet or container for coverage areas.

Liquid products can easily be measured by volume; paste and solid products must be measured by weight. To measure by volume, the use of disposable cups with graduation marks on the side is adequate. Pour the Part A resin and the Part B hardener on top of each other, in the same container. For measurement by weight, a gram scale (for small batches), or a postal scale(for larger batches) is necessary.

Different products have different minimum tolerable application temperatures. Please see the individual product pages on the website or the Technical Data Sheets for the product.

No. Epoxy resin systems are two-part products where each part is designed to go with the other in the specified proportions.

Epoxy adhesives, being gap-filling glues, need only enough clamping to close the joint. Unlike other glues, epoxy requires low pressure and a proper film thickness of resin to make a proper glue joint.