How do I Fiberglass with System Three Epoxy Resins?


Before beginning work with the System Three Epoxy, make sure that surface imperfections are addressed. Use SilverTip QuikFair to fill holes, dings, or to smooth out seams. Sand the wood substrate and the QuikFair using 150-180 grit sandpaper. Clean the surface of loose debris and dust using filtered shop air, vacuum, or a brush.


The first step to doing a good fiberglass job is to seal the wood to avoid the problem of having unsealed wood soak up too much epoxy and starving the wood/glass bond. Apply your favorite System Three Epoxy at ½ fluid ounce per square foot to the bare wood. A 1/8” nap foam roller does a great job applying a thin, uniform coat.


Next lay the fiberglass out on the pre-coated, tack-free surface. Smooth out the fiberglass cloth and do any necessary rough trimming. Masking tape may be necessary to hold the cloth in place if the surface has a slope. Mix small batches of resin initially, until you get the hang of it. Start at one end and pour the resin out over an area equal to about 1 square foot per fluid ounce. Pour in "S" curves, spreading lightly into the dry areas with a squeegee. Let the resin wet the cloth out. Don't try to "force" it through the weave with the squeegee. Notice how the cloth disappears as it wets out. On vertical surfaces, you can work out of a paint tray and apply the System Three Epoxy with a 1/8” nap foam roller.

When the first area has been covered, and the cloth has disappeared, take the squeegee and use reasonable pressure to squeeze the excess resin out of the wet cloth. You can wipe the squeegee edge on a cup or can to remove the resin. Squeegeeing removes excess resin and entrained air, sticking the cloth down right onto the wood surface. The squeegeed cloth should now have a semi- dry look with the weave pattern showing; the cloth itself will be nearly invisible.

Keep going, section by section, until you’re finished. If you are working on a large area use a dry roller cover on the previous three or four sections to give a final smoothing. On smaller boats, the roller cover can be used after the entire hull has been fiberglassed.

Let the Epoxy cure to the "green" stage where it is pliable but no longer tacky unless pressed really hard. Now is the time to trim the excess cloth. Trim by running a sharp, single-edged razor blade around where the glass overhangs the edge. Press down any glass that lifted from the surface while trimming. Make sure to fill the weave within 72 hours for maximum adhesion.


The weave of the cloth can be filled once the resin has reached the green state of cure. Don't try to sand the weave smooth, fill it with epoxy. Apply fill coats. Several coats may be necessary before the weave is filled. If you plan to paint the surface, you may fill the cloth weave with SilverTip QuikFair in one coat using a squeegee to apply it. Don't use any QuikFair on surfaces that are to be clear finished.

When the weave has been filled, the surface should be sanded to prepare it for painting or varnishing. Sand the epoxy, not the fiberglass. Use 150-180 grit sandpaper and be sure to wear a respirator or dust mask while sanding. Clean the epoxy surface well before applying a UV protective topcoat.


Was this article helpful?
0 out of 1 found this helpful



Article is closed for comments.